Tag: 300-360 vce dumps

2016 November Cisco Official New Released 300-360 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

2016 timesaving comprehensive guides for Cisco 300-360 exam: Using latest released Lead2pass 300-360 exam questions, quickly pass 300-360 exam 100%! Following questions and answers are all new published by Cisco Official Exam Center!

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-360.html

QUESTION 31
After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?

A.    The area is below the minimum threshold configured on the tool.
B.    The area is below the detectable level and indicates no RF signal.
C.    The area is below -100 dBm at coverage cell edge.
D.    The area is below -67 dBm at coverage cell edge.

» Read more

2016 November Cisco Official New Released 300-360 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Are you interested in successfully completing the Cisco 300-360 Certification Then start to earning Salary? Lead2pass has leading edge developed Cisco exam questions that will ensure you pass this 300-360 exam! Lead2pass delivers you the most accurate, current and latest updated 300-360 Certification exam questions and available with a 100% money back guarantee promise!

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-360.html

QUESTION 21
An engineer is assigned to provide wireless coverage in a provincial capital building. Due to the age and historic nature of the building, the ability to run new copper Ethernet cable to desired AP locations is limited. Which requirement should the engineer specify to overcome this restriction?

A.    Deploy access points where the survey indicates and connect them via fiber optic cable, using a mediaadapter, and locally provide power.
B.    Deploy access points to each phone location converting two spare pairs of copper from the phone line toEthernet and locally provide power.
C.    Deploy access point devices where limited cable can be run or exists and connect high-gain antennas andincrease Tx power to increase cell size.
D.    Deploy RAP where limited cable can be run or exists, and extend coverage using MAP.

» Read more

2016 November Cisco Official New Released 300-360 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

The Cisco 300-360 exam is a very hard exam to successfully pass. Here you will find free Lead2pass Cisco practice sample exam test questions that will help you prepare in passing the 300-360 exam. Lead2pass Guarantees you 100% pass exam 300-360.

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-360.html

QUESTION 11
Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)

A.    Use the Cisco wireless phone site survey client utility.
B.    Use a separate Cisco Wireless Lan Controller.
C.    Enable load balance on voice WLANs.
D.    Maintain -67dBM as a minimal RSSI.
E.    Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.
F.    Enable lower data rates for 2.4-GHz data WLAN.

» Read more

2016 November Cisco Official New Released 300-360 Dumps in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Lead2pass updates Cisco 300-360 exam questions, adds some new changed questions from Cisco Official Exam Center. Want to know 2016 300-360 exam test points? Download the following free Lead2pass latest exam questions today!

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-360.html

QUESTION 1
A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping.
How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

A.    No outer CAPWAP or inner QoS tagging is applied.
B.    The outer CAPWAP CoS is marked and capped and the inner DSCP maintains the original marking.
C.    No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.
D.    The outer CAPWAP DHCP is marked and capped without any inner DSCP value.

» Read more

2016 July Cisco Official New Released 300-360 Q&As in Lead2pass.com!

100% Free Download! 100% Pass Guaranteed!

Lead2pass is one of the leading exam preparation material providers. Its updated 300-360 braindumps in PDF can ensure most candidates pass the exam without too much effort. If you are struggling for the 300-360 exam, it will be a wise choice that get help from Lead2pass.

Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-360.html

QUESTION 1
A downstream packet that contains a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping.
How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?

A.    No outer CAPWAP or inner QoS tagging is applied.
B.    The outer CAPWAP CoS is marked and capped and the inner DSCP maintains the original marking.
C.    No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.
D.    The outer CAPWAP DHCP is marked and capped without any inner DSCP value.

» Read more